M365 (Classic) fährt nicht mehr

Ist mir auch schon passiert. Hatte abwechselnd Fehlercode 11 und 12 und später dann 21. Roller aufgeschraubt und war von innen nass. Getrocknet und am Ende funktionierte alles wieder, außer das Rücklicht. Ging dann nur noch mit Wechsel des Controllers wieder. Seitdem habe ich vorne und hinten etwas dicht vor dem anschrauben aufgetragen.
 
  • Hilfreich!
Reaktionen: Bigclackbock
Ist mir auch schon passiert. Hatte abwechselnd Fehlercode 11 und 12 und später dann 21. Roller aufgeschraubt und war von innen nass. Getrocknet und am Ende funktionierte alles wieder, außer das Rücklicht. Ging dann nur noch mit Wechsel des Controllers wieder. Seitdem habe ich vorne und hinten etwas dicht vor dem anschrauben aufgetragen.
Also einfach mal trocknen lassen

Weil bis jetzt tut der scooter gar nichts mehr:(
 
Thanks very much

I will make.
Do you happen to know the diameter?
Post automatically merged:

Result after 10 days

My xiaomi m365 ran perfectly true never so satisfied

Unfortunately, I got caught in a downpour today
Does the app show error code 11....

Then I kept myself busy for 1 hour sitting in the shelter and waiting

After an hour and pushing, the scooter ran perfectly again.

Then I just wanted to go home so I drove off and well after 2 kilometers and an emergency stop with 44% battery everything went out and since then there is nothing to do except at about 20-30 km/h the scooter switches on but just beeps no reaction

Anyone have an idea what happened there?
Olli_69 Olli_69
Chrischon

Have now even removed the board was damp

Just let the battery dry or what should I do?
Dry it and clean with isopropyl alcohol. Don't leave it damp to dry it will corrode and the traces will break and never recover.
 
Dry it and clean with isopropyl alcohol. Don't leave it damp to dry it will corrode and the traces will break and never recover.
Did dry it immediately
No corrosion sign seen i think its the bms thats faulty but will need to check later
Post automatically merged:

So habe alles geprüft getrocknet

Bms kann ich noch nicht ausschliessen da ich angst habe mit spannung usw zu arbeiten.

Was ich aber beobachtet habe war das aus dem motor wasser kam???
 
Zuletzt bearbeitet:
Ahh du bist es mit den coolen Namen :D

Was du natürlich machen kannst, ist den Controller auseinander Schrauben und die Platine mit Isopropanol reinigen
Gemacht aber controller ist wie neu bild schicke ich heute noch

Problem besteht weiterhin

Ich kann denn nicht einschalten bin jetzt oben an dem on knopf an arbeiten evtl ist der ja das problem das wasser aus dem motor läuft ist mir aber neu.
War keine pfütze und sonst nichts
 
MikeUK MikeUK
Olli_69 Olli_69

20220913_004029.jpg

Messe ich denn akku richtig?!

3.8Volt sollten ja 1 zelle sein wenn ich richtig bin
 

Anhänge

  • 20220913_004556.webp
    20220913_004556.webp
    137,4 KB · Aufrufe: 37